Placing pieces of excess mesh

Tool(s): Place Individually

After you have selected Excess Mesh Placement, the Excess mesh placement window opens in addition to the active viewport. This window shows all meshes with pieces of excess mesh. The data in all the active drawing files is taken into account. The manner in which the meshes are displayed depends on the settings in the Mesh cutting diagram area on the Reinforcement - Representation page of the Options.

If there is no excess mesh, the program displays an appropriate message.
Note: There may not be any excess mesh even when you place cut mesh. The reason for this is that all cut meshes put together result in whole meshes. For example, two half meshes result in one whole mesh without any excess.

• Click the piece of excess mesh you want to place in the Excess mesh placement window.

  Afterwards, the Excess mesh placement window is closed again.